MYSA BB V3-0
Certified on July 22, 2026, updates are not expected yet
The Thermostat MYSA BB V3-0 by Mysa uses Wi-Fi and is certified for Matter 1.5 since July 2026. Firmware version 5.1 is available.
Price comparison
Compatibility with smart home platforms
Whether the platform supports this device type (Thermostat). This is an assessment based on the platforms’ lists, not a guarantee for every feature.
- Google HomeDevice type supported
- Amazon AlexaDevice type supported
- Apple Home *Device type usually supported
- SmartThings *Device type usually supported
- Home Assistant *Device type usually supported
Data as of 2026-10-28. Platforms keep adding support; check the manufacturer’s information before buying. Platforms marked * publish no list of their own, so the entries are based on reports.
Technical data
- Manufacturer
- Mysa
- Product type
- Heating, cooling & water
- Device type
- Thermostat
- Radio protocol
- Wi-Fi
- Matter version
- Matter 1.5
- Model number
- BB.3.0.01.TB
- First certified
- July 22, 2026
- Certificate ID
- CSA263ZYMAT54590-24
- Vendor / product ID (VID/PID)
- 0x15E6 / 0x0002 (5606 / 2)
Factory reset
General advice
- First remove the device in your smart home app (controller) so its pairing is deleted there.
- Reset the device as the manufacturer describes – often a reset button or a fixed sequence of power cycles. The exact sequence differs per device; use the manual.
- The device then starts in pairing mode. Set it up again with its QR code or setup code.
Resetting erases the device’s settings and assignments.
Manufacturer links
Update history (certified firmware versions)
One version is certified so far (since July 22, 2026). New versions appear here automatically.
| Version | Certified on | Matter | Certificate ID |
|---|---|---|---|
| 5.1 | July 22, 2026 | 1.5 | CSA263ZYMAT54590-24 |
Source: Distributed Compliance Ledger of the Connectivity Standards Alliance (as of November 3, 2026). No guarantee.