Aqara Motion and Light Sensor P2
Only the initial certification so far (November 3, 2022), no update certified
Thread border router required. This device uses Thread and needs a Thread border router, for example a HomePod, Apple TV, Nest Hub or Echo. Compare border routers →
Aqara Motion and Light Sensor P2 by Aqara: certified Matter device (Occupancy sensor). Radio: Thread. Matter 1.0.
Price comparison
No price comparison has been set up for this device yet.
Compatibility with smart home platforms
Whether the platform supports this device type (Occupancy sensor). This is an assessment based on the platforms’ lists, not a guarantee for every feature.
- Google HomeDevice type supported
- Amazon AlexaDevice type supported
- Apple Home *Device type usually supported
- SmartThings *Device type usually supported
- Home Assistant *Device type usually supported
This device uses Thread: the platform needs a Thread border router, for example a HomePod, Apple TV, Nest Hub or an Echo with Thread. Compare border routers →
Data as of 2026-10-28. Platforms keep adding support; check the manufacturer’s information before buying. Platforms marked * publish no list of their own, so the entries are based on reports.
Technical data
- Manufacturer
- Aqara
- Product type
- Sensors
- Device type
- Occupancy sensor
- Radio protocol
- Thread
- Matter version
- Matter 1.0
- Model number
- AS057
- First certified
- November 3, 2022
- Certificate ID
- CSA22084MAT40084-24
- Vendor / product ID (VID/PID)
- 0x115F / 0x2003 (4447 / 8195)
Setup (manufacturer instructions)
1. Please make sure you have the Matter-compatible app and Matter-compatible Thread Border Router. 2. Remove the insulating pull tab. The indicator will start breathing. 3. Open the Matter-compatible app and scan the Matter QR Code on the manual or package, or enter the Matter Setup Code printed on the product to add the device to the app. Please note: If the indicator is not breathing, press and hold the reset button for 5 seconds until the LED indicator starts blinking and release it. The device will enter the pairing mode.
Factory reset
General advice
- First remove the device in your smart home app (controller) so its pairing is deleted there.
- Reset the device as the manufacturer describes – often a reset button or a fixed sequence of power cycles. The exact sequence differs per device; use the manual.
- The device then starts in pairing mode. Set it up again with its QR code or setup code.
Resetting erases the device’s settings and assignments.
Manufacturer links
Update history (certified firmware versions)
One version is certified so far (since November 3, 2022). New versions appear here automatically.
| Version | Certified on | Matter | Certificate ID | Download firmware |
|---|---|---|---|---|
| 1.0.0.0 | November 3, 2022 | 1.0 | CSA22084MAT40084-24 | |
| 1.0.2.0listed in the DCL, not certified | Download firmware (605 KB)SHA-256: 6E5HHnJ6Rn6Y/vUuuNQyQY/3UjmS+ZU/BqzTw0YSrZU= |
The files are hosted by the manufacturer and only linked here (details and checksum from the CSA DCL). Matter devices usually update automatically through the manufacturer’s app; manual installation is only needed if the manufacturer provides for it. Use at your own risk.
Articles about this device
Source: Distributed Compliance Ledger of the Connectivity Standards Alliance (as of November 3, 2026). No guarantee.